menzies
Guru
I am having an issue with my B&G depth sounder. I have a Raymarine for redundancy so not critical, more annoying.
It reads fine, matching the other reading, then it starts dropping through the numbers down to zero, and after a few seconds starts coming back up again to the accurate reading. This happens pretty constantly.
Any thoughts on where to troubleshoot, or just better/easier to replace the transducer on the next haul?
It reads fine, matching the other reading, then it starts dropping through the numbers down to zero, and after a few seconds starts coming back up again to the accurate reading. This happens pretty constantly.
Any thoughts on where to troubleshoot, or just better/easier to replace the transducer on the next haul?