Heron
Guru
- Joined
- Nov 5, 2014
- Messages
- 1,304
- Location
- USA
- Vessel Name
- Heron (2)
- Vessel Make
- '88 Cape Dory 28 Flybridge #115
This weekend my Raymarine ST6002 seemed to lose it's mind while using my wireless remote...Thinking the Batteries needed replacing, I did to no avail. It seems the rudder position sensor was going wonky from the symptoms. Now I get NO rudder position information on the main display, though all other set-up parameters are working fine and accessible. Connections at the computer are clean and not corroded. I pulled the sensor and exercised the potentiometer a bit and got a reading on the main display, which disappeared again when rebooted. I suspect the sensor went bad. Unit is 15 yrs. old. Any one else experience a failure here?
Last edited: