One bolt on the inspection plate of one fuel tank is weeping.* When the fuel level was down enought we*removed the nut, cleaned it and the bolt, put gasket sealant on it and replaced the nut.* Initially it seemed to work but it is now weeping again.* Short of removing the entire inspection plate has anyone had success fixing this type of leak.* Thanks.
fuel tank inspection plate bolt weeping
- Thread starter NComfort
- Start date
The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.
If you have answers, please help by responding to the unanswered posts.
Well, if it's diesel, (not had experance on gas) you will need to re-thread the bolts 'nut' the plate that the bolt screws into.
Often times (me included) we over tighten the bolt resulting in the 'nuts' thread being damaged.
You could check this thread with a magnifying glass or similar to look for bent over threads, same for the bolt.
-- Edited by DaEdster on Wednesday 8th of February 2012 03:19:09 AM
Often times (me included) we over tighten the bolt resulting in the 'nuts' thread being damaged.
You could check this thread with a magnifying glass or similar to look for bent over threads, same for the bolt.
-- Edited by DaEdster on Wednesday 8th of February 2012 03:19:09 AM
2DASEA
Veteran Member
- Joined
- Dec 21, 2011
- Messages
- 78
Might be your tank telling you to have a look inside......
