dhays
Guru
- Joined
- May 26, 2015
- Messages
- 9,052
- Location
- United States
- Vessel Name
- Kinship
- Vessel Make
- North Pacific 43
This is a very basic question and I feel kind of silly asking but...
I have a dry bilge pump I want to install. It is simply a low capacity, and low profile pump designed to get out the last bit of water from the bottom of the bilge that the regular bilge pump doesn’t get.
I don’t want to create another thru-hull so I am going to run the outflow from this into the shower sump where the shower sump pump will pump it overboard. I also would like to put in on the same electrical circuit.
I want to splice the + and - of this new bilge pump into + and - wire for the shower sump pump. So my question is this...
What is a good way to splice the wires in the bilge area? They shouldn’t be wet, but they should be able to get wet if you follow me.
I have a dry bilge pump I want to install. It is simply a low capacity, and low profile pump designed to get out the last bit of water from the bottom of the bilge that the regular bilge pump doesn’t get.
I don’t want to create another thru-hull so I am going to run the outflow from this into the shower sump where the shower sump pump will pump it overboard. I also would like to put in on the same electrical circuit.
I want to splice the + and - of this new bilge pump into + and - wire for the shower sump pump. So my question is this...
What is a good way to splice the wires in the bilge area? They shouldn’t be wet, but they should be able to get wet if you follow me.