I've long had to err on the side of caution when making things 'as tight as possible...' as in, they break.
I just 'finished' (but not done yet) replacement of the freshwater pump and filter (element and housing). Once I had the wiring done, I turned it on and... had impressive leaks at both the pre-pump screen filter and the post-pump micron filter.
The pump is a Shurflo Aquaking II, rated at 3 gpm, and though the filter element 'recommends' 2gpm I didn't think that would be a problem... is it?
I can tighten both housings more, but didn't think anything beyond 'firm' was required... is it?
I've done a lot of house plumbing, but this is my first boat plumbing. I'm spending another night without running water, will face this fresh tomorrow.
Any input appreciated, as always...
Bob
I just 'finished' (but not done yet) replacement of the freshwater pump and filter (element and housing). Once I had the wiring done, I turned it on and... had impressive leaks at both the pre-pump screen filter and the post-pump micron filter.
The pump is a Shurflo Aquaking II, rated at 3 gpm, and though the filter element 'recommends' 2gpm I didn't think that would be a problem... is it?
I can tighten both housings more, but didn't think anything beyond 'firm' was required... is it?
I've done a lot of house plumbing, but this is my first boat plumbing. I'm spending another night without running water, will face this fresh tomorrow.
Any input appreciated, as always...
Bob