Simi 60
Guru
- Joined
- Jul 1, 2016
- Messages
- 5,482
- Location
- Australia
- Vessel Make
- Milkraft 60 converted timber prawn trawler
Pyrometer/exhaust temp on my Cummins NT855 has never registered since we had it and as the motor runs sweet as and had been checked over we at that stage weren't to concerned and still arent really, but, if we can fix it we will.
It seem to me, after pulling the probe, that it is rooted as there is only about 1/8th of an inch sticking out the end and any pictures I see all seem to have a couple of inches of probe sticking out.
Can I just buy a generic probe such as the one listed below?
EGT Temperature Sensors K type for Exhaust Gas Temp Probe (1m ~5m) Special***
This seems to be same same apart from the connector which on my dead Barber Colman co. probe pictured below, is a easily changed plug.
It seem to me, after pulling the probe, that it is rooted as there is only about 1/8th of an inch sticking out the end and any pictures I see all seem to have a couple of inches of probe sticking out.
Can I just buy a generic probe such as the one listed below?
EGT Temperature Sensors K type for Exhaust Gas Temp Probe (1m ~5m) Special***
This seems to be same same apart from the connector which on my dead Barber Colman co. probe pictured below, is a easily changed plug.
Attachments
Last edited: