View Single Post
Old 07-27-2017, 08:08 AM   #31
Ski in NC
Technical Guru
 
Ski in NC's Avatar
 
City: Wilmington, NC
Country: USA
Vessel Name: Louisa
Vessel Model: Custom Built 38
Join Date: Jan 2014
Posts: 5,451
Tab washer should be ok. Should also be able to drill the cotter pin hole in the shaft while installed. It might be a tough SS, but it is not that tough. A good bit and proper cutting fluid and a battery drill should do it.

Domed nut may be fine, as it has held up for a long time. Just would rather see a very positive restraint should a nut loosen. Two nuts and a cotter are dead reliable.
Ski in NC is offline   Reply With Quote