Leak at hull/deck
We had a water leak into the aft end of the salon, portside. The inside of the cabinet and floor would get wet during heavy rain. I removed the trim piece from amid ship to the transom. The aft end came apart quite easily while the forward portion was better adhered. I found that the deck to hull joint was open for about a foot. I injected 3M 5200 into the open area and then used the same along the entire length to address other suspect areas. After it set up, I reinstalled the trim piece with clear silicone (in case it needed to be removed again) making sure the screws were properly bedded. The deck was solid fiberglass with no coring, so there was no real need to dry it out before the repair work was done. The project was done this past fall after the boat had been hauled but after several rains, there seems to be no further water intrusion in that area.