I use method in post #5 for engine and generator.
I did add a brass tee to sea cock side of AC strainer with brass hose cap. I install a 3/4 x 3/8" hose into bucket to suck up 50/50 fluid. I disconnect the potable water pump at suction hose from tank and use the same hose to do the potable water system. I have the bypass hose and valves on the hot water heater. I vacuum out all strainers and bilge of any water. I pour a couple gallons of 50/50 in the bilge and actuate the bilge pump switches.
Once complete I'm Ready for winter and any projects I have been putting off during the summer season.
|