freshalaska
Senior Member
- Joined
- Oct 2, 2010
- Messages
- 150
- Location
- Skagway Alaska and Florida
- Vessel Name
- Nowitna and Serenade
- Vessel Make
- Schucker and 46 foot Ted Brewer custom sailboat
I was going to put two zinc collars (double zinc) on my prop shaft and that left me with about 1/2 inch clearance between the cutlass bearing and the zinc and someone told me that wasn't enough clearance for bearing to get sufficient water lubrication. Does this sound correct? How much clearance is enough?
Thanks all!
Thanks all!