View Single Post
Old 09-26-2016, 11:19 AM   #676
She-Kon
Senior Member
 
She-Kon's Avatar
 
City: Iroquois, ON
Country: Canada
Vessel Name: She:Kon
Vessel Model: Bateau TW28
Join Date: Jun 2014
Posts: 466
Quote:
Originally Posted by Nomad Willy View Post
Rick,
Why won't those welds (ribs/frames) to rudder shaft be over stressed? Perhaps the overlay is flush w the side/edge of the shaft and greatly adds purchase to the rudder skin? From what I see I would be thinking about putting in some doubblers on the frames to shaft joint.

It's easy to get the habbit of overbuilding and getting too heavy. Is this rudder per plans?
Hi Eric

The rudder was fashioned after one that was built in Holland a few years ago. Same materials, same specs. I follow what you're saying about the frames to shaft joint and can easily add some gussets while it's all wide open. Can't hurt and it doesn't cost anything.

Cheers!
__________________
Yours Aye! Rick
~^~^~^^~^~^~^~^~^~^~^~~^~^~~^~^~^^~~^~^
"It's not the boat "you built" until you've sworn at it, bled on it, sweated over it, cried beside it and then threatened to haul the POS outside and burn it!"
She-Kon is offline   Reply With Quote