Quote:
Originally Posted by pacopico
673's have a integrated fan/flywheel combination. Good luck.
|
So the way this works, is if all the measurements Work out to a standard SAE bell housing, and flex plate then ANY brand generator end will work (any brand that uses the industry standad SAE sizing system)
If the measurements do not correspond to a standard SAE size then folks are forced to go back to the generator manufacturer for a replacement.
As I indicated I do not have hands on experience replacing the generator end on the NL 673, so I cannot speak as to wether these use SAE adaption, or some NL propritary size.
What I can say is that once the generator end is off, you can determine the SAE sizes in just a few minutes using a framing square and a tape measure.