MikeM
Senior Member
I've attached two pictures below. One is the engine raw water strainer. It was manufactured by Bair...apparently out of business. The second picture is of a stainless steel elbow that comes out of the strainer. The connects the 1 1/2" stainer outlet to the 1" ID hose going to the raw water pump.
The elbow has some corrosion on it, and I would like to replace it. I've been advised by Brian Smith at ADC to go with a brass or bronze elbow. But I have not found anything that reduces from 1 1/2" to 1" in my searches. I also don't know if the strainer threads are NPT or NPS.
Any ideas on what I should get or where to get it.
Thanks!
Mike
a
Mike Metts
KK 42-165
Virginia Beach, VA
Sent from my iPad using Trawler Forum
The elbow has some corrosion on it, and I would like to replace it. I've been advised by Brian Smith at ADC to go with a brass or bronze elbow. But I have not found anything that reduces from 1 1/2" to 1" in my searches. I also don't know if the strainer threads are NPT or NPS.
Any ideas on what I should get or where to get it.
Thanks!
Mike
a
Mike Metts
KK 42-165
Virginia Beach, VA
Sent from my iPad using Trawler Forum