View Single Post
Old 01-22-2016, 11:08 PM   #3
C lectric
Guru
 
C lectric's Avatar
 
City: Gibsons, B.C.
Country: Canada
Vessel Name: Island Pride
Vessel Model: xxxx
Join Date: Oct 2007
Posts: 2,630
If you have a push button to stop setup then it could be the solenoid or its associated wiring is faulty, it could be the push button itself or its associated wiring is faulty. Wiring could be corroded or loose.

I know the older Lehmans had the solenoid, just don't know about your 135.

Use a voltmeter to check voltage at the P.B. and ensure that there is full voltage and no iffy bouncing around. Same for the solenoid.

Also ensure there is a GOOD ground at the solenoid. If not then it cannot work properly.

The solenoids do have a finite life as do P.B. Most likely one or the other.
C lectric is offline   Reply With Quote