DC Clip on Amp Meters

The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

BigJim

Senior Member
Joined
Oct 5, 2012
Messages
177
Location
USA
Do they work, are they accurate? I have always used shunts and in series with my Fluke.

My current measurements never go above 100 Amps. The shunt work is a little scary as I have different configurations and am concerned about a nuclear meltdown.
 
Do they work, are they accurate? I have always used shunts and in series with my Fluke.

My current measurements never go above 100 Amps. The shunt work is a little scary as I have different configurations and am concerned about a nuclear meltdown.

Big Jim, do you mean an inductive amp meter??
 
Yes, they work and well. If buying one get one that can read in RMS, in both AC & DC. Otherwise reading many inverters will result in screwy readings.

Ultimately they may not be as completely accurate as your shunts but there is no disconnecting and reconnecting so checks can be made easily, safely , quickly. Also means checks will be made as needed. In most cases if there is a difference between the clamp on and the shunt readings it will not be of signifigance.

If you find a screwy reading with the clamp on then you can go for the shunt accuracy.

My example: I was having trouble with load handling loss with my three Gel Cell batteries. I found the problem one with the clamp on. Load testing individually had not shown the bad battery. I finally set up a load common to all three and monitored the current from each. It showed two batteries current was increasing, one was dropping. As I watched the bad one eventually flipped polarity meaning it had now become a load to the other two. Removed the bad one and got tow more years out of the remaining two units.

If I had to connect and disconnect I likely would have missed the significance. To monitor in real time I would have needed three meters and shunts. With the one clamp meter I could quickly move it around. Of course it wasn't real time but it fast enough and I could see well enough what was happening.

Note: I have my meter because I needed it for work. I did not buy it just for the boat. Can measure up to 1,000A so that should enter into your decision but since I bought mine they have come down a lot in price and also there are more of them available. Klien Tools makes one that should be suitable for you with a much reduced current capacity which keeps the price down. Also available at Home Depot.


http://www.amazon.com/Klein-Tools-CL2000-Clamp-Meter/dp/B003LH7NH2
 
Last edited:
There are two types of clamp on ammeters: inductive for AC measurements and Hall effect for DC measurements. DC meters almost always include AC measurements.

So make sure you buy the combination meter for boat diagnostics.

David
 
Blue sea at fishires supply $100 good one
Don
 
Blue sea at fishires supply $100 good one

The price on that one is showing at $166. If you want quality, I recommend the Fluke 374, about $300.
 
Back
Top Bottom