Dune
Senior Member
Full beam standup engine room, has 4 plywood floor panels between the engines that can be raised to access batteries, seacocks, strainers, etc. Wondering what I might cover those 3/4" plywood panels with that would look "high tech" but not be heavy....as the plywood is already pretty heavy by itself.
Ideally something that could be cut with carpet knife...like rubberized diamond plate or tread pattern.... but thinner than usual so not so heavy ? Or aluminum diamond plate that is so thin it could be cut with tin snips ? or ?
Ideally something that could be cut with carpet knife...like rubberized diamond plate or tread pattern.... but thinner than usual so not so heavy ? Or aluminum diamond plate that is so thin it could be cut with tin snips ? or ?