Lollipop
Veteran Member
I have two cutlass supports and thus brgs. on each shaft. On the starboard shaft, the cutlass brgs. are marginal and I figure I need to replace them while the boat is on the hard to prevent problems down the road. The Port side are tight, very tight, and seem to be fine. I know, knock them all at and make it new again, but I am replacing perfectly good parts with perfectly good parts. Looking for other opinions...
I have checked the shaft, prop, alignment, and all looks good...Not sure why the Starboard side is worn more unless the port was replaced prior...They do look a little different.
I have checked the shaft, prop, alignment, and all looks good...Not sure why the Starboard side is worn more unless the port was replaced prior...They do look a little different.