Spike
Senior Member
- Joined
- Dec 13, 2010
- Messages
- 143
- Location
- USA
- Vessel Name
- Chasing 80
- Vessel Make
- Chris Craft Constellation 460
I'm looking to replace the anchor roller on our bow pulpit but not having much luck. It seems to be a bit larger than the wheels I'm finding on the internet.
Size is 6" x 2.5/8" with a .75 hole in the center. The hole accepts a threaded sleeve/bushing that accepts screws on each side to attach to the mount. I imagine I could drop down to a 5" roller but all those I see are too wide, 3.75" at least.
I'll be in FLL & the Keys next weekend if anyone has ideas for a larger supply store. HopCar, I'll stop for a Cuban Coffee if nothing else!
Thanks in advance.
Size is 6" x 2.5/8" with a .75 hole in the center. The hole accepts a threaded sleeve/bushing that accepts screws on each side to attach to the mount. I imagine I could drop down to a 5" roller but all those I see are too wide, 3.75" at least.
I'll be in FLL & the Keys next weekend if anyone has ideas for a larger supply store. HopCar, I'll stop for a Cuban Coffee if nothing else!
Thanks in advance.