AKDoug
Guru
I have to drill several holes through my foredeck to mount the anchor windlass pedestal, the deck being fiberglass over plywood over fiberglass, perhaps an inch and a half thick. I need to seal the wood core, but have no idea how to go about it in the best way. If it were a balsa core, it's well documented. Can I just use something like "Git Rot" as a penetrant sealer for my 3/8" through holes for the base mount?
Drilling oversize holes doesn't seem like the best answer.
Looking for some tips here I will post some pictures of the finished project when done, the project just being at the "fit the pedestal" before final welding on the chain pipe. And boring holes in my foredeck with a drill and a few hole saws...
Drilling oversize holes doesn't seem like the best answer.
Looking for some tips here I will post some pictures of the finished project when done, the project just being at the "fit the pedestal" before final welding on the chain pipe. And boring holes in my foredeck with a drill and a few hole saws...