Scary
Guru
I'm using this two part polyurethane varnish for the first time. I have seen results that were very impressive using it so I thought I'd give it a try on a drop leaf table I'm building. This product is clear and high gloss without amber tinting but still claims to have good UV protection. Anybody used this product, sprayed or brushed? The first two coats have been applied with a HVLP to raw African Mahogany reduced 25% with their recommended reducer. It can recoated after 3hrs at 97deg or 4 hrs at 75deg without sanding. The product seems to apply easily but is prone to run at the this reduction if applied like varnish. It acts like clear Algrip, which it in fact may be similar to. I will spray the next three or four coats at full strength if possible to get through the gun. At some point I will have to sand the table smooth to apply the finish high gloss top coats. I'd like some feed back on others experiences with this product.