View Single Post
Old 06-25-2014, 06:39 AM   #13
Ski in NC
Technical Guru
 
Ski in NC's Avatar
 
City: Wilmington, NC
Vessel Name: Louisa
Vessel Model: Custom Built 38
Join Date: Jan 2014
Posts: 6,194
Cutless bearings are not a tight fit. A little slop with new bearing and new shaft is normal. You measure 0.015" play, that is fine. Once run in, it will increase a bit, still ok. I consider 1/16 fine (0.0625). When running, hydro forces on wheel load the shaft against the bearing in one spot, so it tends not to clunk around. I've seen things worn to 1/8", and there were no complaints. Just noticed when hauling for paint. Good to change then, though.
Ski in NC is offline   Reply With Quote