timjet
Guru
- Joined
- Apr 9, 2009
- Messages
- 1,920
I am making a mount for my chart-plotter that will tilt it 20 degrees to the right. The unit is located about 2 feet left of the steering wheel and by tilting it 20 degrees should make it easier to read.
I made the mount out of 1/2 " plywood. I want to apply a gloss finish so it looks like it's part of the boat and not just some add on project.
I am thinking of using a product like Interlux Perfection, a two part epoxy paint that results in a gloss finish. I don't know if this is the proper product to use on plywood and what preparation is needed to apply the epoxy.
Anybody have suggestions. I've looked for a You Tube video, but none seems to address applying epoxy paint over plywood.
Thanks guys.
I made the mount out of 1/2 " plywood. I want to apply a gloss finish so it looks like it's part of the boat and not just some add on project.
I am thinking of using a product like Interlux Perfection, a two part epoxy paint that results in a gloss finish. I don't know if this is the proper product to use on plywood and what preparation is needed to apply the epoxy.
Anybody have suggestions. I've looked for a You Tube video, but none seems to address applying epoxy paint over plywood.
Thanks guys.