A very simple method of creating factory look no skid is,
sand and prep the NS area and outline the specific area with a pencil line.
Obtain COTTON coarse pattern mosquito net , cut it to fit the outline and iron it flat.
Use a thin coat of 2 part epoxy paint and lay the cotton into the paint by the marks.
After an hour roll a second light coat ( do not fill the mesh) and the cotton will absorb the paint , leaving a fine looking surface .EZ to clean.
Easy to repair as only sanding paint off is required. NOT sanding off sand.
With flight deck flint embedded in epoxy ,on LUCY, I only wish I could use this technique and go bare foot about the boat.
|