Good Day,
I removed a leaky hot water heater that ran off the waste heat of the engine. By the looks of it, I'd say it was one of the Seward Products heat exchangers.
What should I do with the two connections to the engine (it is a Cummins 4bt)?
I guess there are two options:
1. stop them off (i.e. plug the inlet/outlets as if they never existed)
2. run a hose from one to the other (kind of simulating that the HW heater was still there
Thanks.
I removed a leaky hot water heater that ran off the waste heat of the engine. By the looks of it, I'd say it was one of the Seward Products heat exchangers.
What should I do with the two connections to the engine (it is a Cummins 4bt)?
I guess there are two options:
1. stop them off (i.e. plug the inlet/outlets as if they never existed)
2. run a hose from one to the other (kind of simulating that the HW heater was still there
Thanks.