Thread: Cable Crimper
View Single Post
Old 06-20-2009, 03:52 AM   #7
FF
Guru
 
FF's Avatar
 
Join Date: Oct 2007
Posts: 19,923
RE: Cable Crimper

To get a "proper" (made both mechanically and electrically ) terminal end requires some concern.

We use Anchor wire and Anchor terminal ends and the Anchor brand crush tool.

IT will only release after sufficient force is used to "cold flow) the solder.

THE requirement for a good end.

Weather the Chinese Hyd unit has any such protection is open to inspection.

So I would dip any Chinese ends in a solder dunk, to be sure on the electric requirement .

FF
FF is offline   Reply With Quote