View Single Post
Old 03-16-2013, 09:06 PM   #2
Brooksie
Guru
 
Brooksie's Avatar
 
City: Cape Cod, MA
Country: USA
Vessel Name: Island Seeker
Vessel Model: Willard 36 Sedan
Join Date: Oct 2007
Posts: 989
Some Perkins experience here. They all look very tough but you can't tell much by looking about how they are injecting.
One (and only one) washer each is correct.
By all means have them rebuilt.
You should be able to hook the washers out with a curved pick, just be sure you get a good quality one from your tool seller; you can't have anything snap off and go in the cyl.
Clean the bores in the head, and install the rebuilt injectors dry without anything that will interfere with heat transfer.
Brooksie is offline   Reply With Quote