Showing results 1 to 25 of 81
Search took 0.00 seconds.
Search: Posts Made By: captbuddy
Forum: Prairie 04-19-2023, 07:36 PM
Replies: 3
Views: 1,102
Posted By captbuddy
Capt Marvin. I don’t think so because I got vents...

Capt Marvin. I don’t think so because I got vents just go the left of hole on starboard side and same just to right on port side. I guess a previous owner could have installed the long gated vents...
Forum: Prairie 04-03-2023, 10:34 AM
Replies: 20
Views: 1,845
Posted By captbuddy
Not yet.

Not yet.
Forum: Prairie 04-02-2023, 08:22 PM
Replies: 20
Views: 1,845
Posted By captbuddy
The meter is at 13 when key is off. As soon as...

The meter is at 13 when key is off. As soon as you turn key on the meter is pegged and when you crank the engine it stays pegged. I thought maybe it was because I had inverter charger on when I...
Forum: Prairie 03-30-2023, 07:17 PM
Replies: 20
Views: 1,845
Posted By captbuddy
It doesn’t make a sweep. It just stays there...

It doesn’t make a sweep. It just stays there pegged when you turn key on. Will check with meter. Thanks
Forum: Prairie 03-29-2023, 10:07 PM
Replies: 20
Views: 1,845
Posted By captbuddy
Thanks guys. Will let you know what I find.

Thanks guys. Will let you know what I find.
Forum: Prairie 03-29-2023, 10:02 PM
Replies: 16
Views: 1,987
Posted By captbuddy
It stays in the water.

It stays in the water.
Forum: Prairie 03-29-2023, 07:04 PM
Replies: 20
Views: 1,845
Posted By captbuddy
Forgot to send the other photo

Forgot to send the other photo
Forum: Prairie 03-29-2023, 07:01 PM
Replies: 20
Views: 1,845
Posted By captbuddy
Volt meter

What makes a volt meter peg out when you turn me on and then go back to middle when you turn key off.
Forum: Prairie 03-29-2023, 06:55 PM
Replies: 16
Views: 1,987
Posted By captbuddy
I tried to upload a 30 second video but it said...

I tried to upload a 30 second video but it said not allowed. It might just be me trying to be to perfect. Will loosen bolts and replace tighten. Thanks
Forum: Prairie 03-29-2023, 06:52 PM
Replies: 16
Views: 1,987
Posted By captbuddy
I tried to post a 30 secco deal but it wouldn’t...

I tried to post a 30 secco deal but it wouldn’t upload. Said it wasn’t allowed. I will loosen up bolts and re tighten. It’s probably just me trying to be to perfect. Thanks
Forum: Prairie 03-29-2023, 04:26 PM
Replies: 16
Views: 1,987
Posted By captbuddy
Alignment of shaft.

Is there a trick to getting the shaft back to where it was exactly. After replacing real seal in transmission I pulled shaft back up aligning the bolts and tighten them up. It appears I might have a...
Forum: Prairie 03-28-2023, 08:46 PM
Replies: 6
Views: 1,290
Posted By captbuddy
Guy’s after I finished putting everything back...

Guy’s after I finished putting everything back together there seems to be a very slight miss alignment of the shaft. Can someone tell me the trick to putting shaft back exactly like it was. Thanks
Forum: Prairie 02-07-2023, 06:42 PM
Replies: 33
Views: 4,652
Posted By captbuddy
New Flooring

Just put new flooring and framed all the hatches at the same time. I am very pleased the way it turned out.
Forum: Prairie 02-07-2023, 08:55 AM
Replies: 33
Views: 4,652
Posted By captbuddy
I’m 75 and it makes me mad when people think due...

I’m 75 and it makes me mad when people think due to my age I shouldn’t be doing something. Age is just a number to me. I’ve always believed that if you don’t use it, you will loose it. I am very...
Forum: Prairie 01-31-2023, 10:49 PM
Replies: 6
Views: 1,290
Posted By captbuddy
Just saying thanks to everyone that gave me...

Just saying thanks to everyone that gave me advice. Job is complete and I didn’t have any bolts or washers left over. Waited a day and put new fluid in. Ran engine put in gear and no leaks. It’s a...
Forum: Prairie 01-23-2023, 09:06 PM
Replies: 6
Views: 1,290
Posted By captbuddy
No Jeff, I was planning on replacing it with...

No Jeff, I was planning on replacing it with transmission in place watched a utube video and it seem pretty simple if I can get my shaft back a little bit
Forum: Prairie 01-23-2023, 08:39 PM
Replies: 6
Views: 1,290
Posted By captbuddy
C71 Borg Warner res seal replacement

Need to replace rear seal but was hoping someone could help me on how to remove the coupling so I can get to the coupling nut on the transmission shaft.
Forum: Prairie 01-04-2023, 02:05 PM
Replies: 3
Views: 1,102
Posted By captbuddy
Hole in wall of side step

Can someone tell me what these holes were cut for? Is it factory cut. I don’t think so. To ragged. Have same hole on both sides of my 29 Prairie. These were covered with a piece of teak. The two...
Forum: Prairie 05-24-2022, 05:47 PM
Replies: 44
Views: 4,191
Posted By captbuddy
I just did my final check. I connected a short...

I just did my final check. I connected a short jumper to the original wire coming from flybridge with a single female terminal on the end. Cranked engine and tach is working. That shows me my...
Forum: Prairie 05-24-2022, 05:15 PM
Replies: 44
Views: 4,191
Posted By captbuddy
Thanks Dave. I agree on Turner’s find.

Thanks Dave. I agree on Turner’s find.
Forum: Prairie 05-24-2022, 05:14 PM
Replies: 44
Views: 4,191
Posted By captbuddy
Thanks Turner. I’m going to check one more thing...

Thanks Turner. I’m going to check one more thing before I order that but it looks like that’s my fix.
Forum: Prairie 05-24-2022, 03:53 PM
Replies: 44
Views: 4,191
Posted By captbuddy
Ok guys. I have tied into wire just prior to plug...

Ok guys. I have tied into wire just prior to plug and rpm does not work. Put another female terminal back on jumper and put back on lead at alternator. Rpm works. So it is obvious to me that for...
Forum: Prairie 05-24-2022, 01:10 PM
Replies: 44
Views: 4,191
Posted By captbuddy
Guys, I took my jumper wire from sending unit on...

Guys, I took my jumper wire from sending unit on back of tach and attached it to the lead on the alternator. Cranked engine and rpm is working. Right now not sure if it is the three prong plug at...
Forum: Prairie 05-21-2022, 11:27 AM
Replies: 44
Views: 4,191
Posted By captbuddy
Thanks Steve

Thanks Steve
Forum: Prairie 05-17-2022, 09:33 PM
Replies: 44
Views: 4,191
Posted By captbuddy
Don, I think I found it this time. I found...

Don, I think I found it this time. I found another brown wire past the junction plug. It went to a 3 prong plug that plugs into the bottom of the alternator. I check the ohms from the gray wire to...
Showing results 1 to 25 of 81

 
Forum Jump


All times are GMT -5. The time now is 04:20 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2006 - 2012