Twin Disc MG-5050A - Good Used HD Marine Gear Transmission -
- For Sale - $ 2,600.oo
Reduction Ratio – 1.8 : 1 ----- unit weighs 200 Lbs.
10-degrees down angle output flange
Has an interchangeable & easily replaceable SAE J617 Bell Housing – Number # 3.
Comes with two – one left & one right, - removable mounting brackets
Design is a Vertical Offset, & is in an Aluminum Case
Mechanical control vale suitable for cable control – “F - & -N- & -R”
Twin Disc Serial #: 5JK737 --- Twin Disc – BOM NO: S-8786
NO engine Flexible Coupling or Flywheel Drive Adapter or Damper
NO Oil Cooler, NO PTO, & but does have Standard Oil Strainer Equipped
Unit is a 2005 unit, so it is about 13 years old,
However, only has about 400 hours of usage on it.
Was bolted to a John Deere 6068 Diesel, also fit Caterpillar Diesel Engines, Cummings Diesel Engines among others.
This is a very strong HD unit & Rated HP for usage as follows:
M-1 – Continuous Duty – 156 HP @ 2100 RPM
M-2 – Medium Duty – 172 HP @ 2100 RPM
M-3 – Intermediate Duty – 251 HP @ 2500 RPM
M-4 – Light Duty – 341 HP @ 2800 RPM
M-5 – Pleasure Craft – 365 HP @ 2800 RPM
Maximum Allowable Rated Engine speed 3300 RPM
Rating shown are for use with standard Right-Hand Rotation Engines
Thanks for your interest. Pictures below:
Alfa Mike
Any Questions contact me.
My e-mail is: alfa mike 8277 at yahoo dot com
Thanks.
Mike
- For Sale - $ 2,600.oo
Reduction Ratio – 1.8 : 1 ----- unit weighs 200 Lbs.
10-degrees down angle output flange
Has an interchangeable & easily replaceable SAE J617 Bell Housing – Number # 3.
Comes with two – one left & one right, - removable mounting brackets
Design is a Vertical Offset, & is in an Aluminum Case
Mechanical control vale suitable for cable control – “F - & -N- & -R”
Twin Disc Serial #: 5JK737 --- Twin Disc – BOM NO: S-8786
NO engine Flexible Coupling or Flywheel Drive Adapter or Damper
NO Oil Cooler, NO PTO, & but does have Standard Oil Strainer Equipped
Unit is a 2005 unit, so it is about 13 years old,
However, only has about 400 hours of usage on it.
Was bolted to a John Deere 6068 Diesel, also fit Caterpillar Diesel Engines, Cummings Diesel Engines among others.
This is a very strong HD unit & Rated HP for usage as follows:
M-1 – Continuous Duty – 156 HP @ 2100 RPM
M-2 – Medium Duty – 172 HP @ 2100 RPM
M-3 – Intermediate Duty – 251 HP @ 2500 RPM
M-4 – Light Duty – 341 HP @ 2800 RPM
M-5 – Pleasure Craft – 365 HP @ 2800 RPM
Maximum Allowable Rated Engine speed 3300 RPM
Rating shown are for use with standard Right-Hand Rotation Engines
Thanks for your interest. Pictures below:
Alfa Mike
Any Questions contact me.
My e-mail is: alfa mike 8277 at yahoo dot com
Thanks.
Mike