Tom.B
Moderator Emeritus
- Joined
- Jul 30, 2009
- Messages
- 5,839
- Location
- USA
- Vessel Name
- Skinny Dippin'
- Vessel Make
- Navigator 4200 Classic
I have a couple of cooling questions.
I have a plan to flush out the heat exchanger with Peak radiator flush. Reading the directions, it's a pretty involved process of drain, fill with water, run to temp, drain, fill with water again (I assume to get the coolant out of the block that is behind the thermostat). Then fill with water and flush and run for a few hours with just the flush/water combo. Any pointers you all can give here? It seem pretty straight-forward. Is there any danger to running with just water or in leaving the flush/water mixture in the cooling system for a week between our trips?
Thanks.
Tom-
I have a plan to flush out the heat exchanger with Peak radiator flush. Reading the directions, it's a pretty involved process of drain, fill with water, run to temp, drain, fill with water again (I assume to get the coolant out of the block that is behind the thermostat). Then fill with water and flush and run for a few hours with just the flush/water combo. Any pointers you all can give here? It seem pretty straight-forward. Is there any danger to running with just water or in leaving the flush/water mixture in the cooling system for a week between our trips?
Thanks.
Tom-