Morse Twin-S control head
- Thread starter meridian
- Start date
The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.
If you have answers, please help by responding to the unanswered posts.
Sailor of Fortune
Guru
Don't lose the small retaining screws and e clips.
I would recommend taking a photo of every step from before the new cables to after you install them. It really helps with the memory of how they were adjusted.
Also the pdf manual for your model of morse Control is probably out there to download. Here is one I refer to. Good instructions on any adjusting to do if needed and great illustrations.
http://www.equipment.ath.cx/instrument_pdf/Morse MT3 Manual.pdf
Also the pdf manual for your model of morse Control is probably out there to download. Here is one I refer to. Good instructions on any adjusting to do if needed and great illustrations.
http://www.equipment.ath.cx/instrument_pdf/Morse MT3 Manual.pdf
Shoalwaters
Guru
- Joined
- Feb 24, 2008
- Messages
- 681
- Location
- St. Lucia, West Indies
- Vessel Name
- "Dragon Lady"
- Vessel Make
- DeFever 41
All good advice above.
I have Teleflex/Morse NB levers and I replaced the throttle and gear cables to both stations. Although the internals are somewhat different from yours, the same procedure applies. You may find the description in the link below useful. The little ferrule I made to join the old and new cables made threading the new cables a simple job. Good luck.
http://www.trawlerforum.com/forums/s6/renewing-engine-control-cables-8186.html
I have Teleflex/Morse NB levers and I replaced the throttle and gear cables to both stations. Although the internals are somewhat different from yours, the same procedure applies. You may find the description in the link below useful. The little ferrule I made to join the old and new cables made threading the new cables a simple job. Good luck.
http://www.trawlerforum.com/forums/s6/renewing-engine-control-cables-8186.html
