sdowney717
Guru
- Joined
- Jan 26, 2016
- Messages
- 2,264
- Location
- United States
- Vessel Name
- Old Glory
- Vessel Make
- 1970 Egg Harbor 37 extended salon model
I think they should all be like this from factory for a boat.
The wiper motors that use this push on design corrode and or wear the little splines, even a new blade did not fix the problem. I had prior done the other 2 wiper arms and now this new blade has gotten loose on the motor shaft.
Using a set screw also allows for easy positioning. The other two I did years ago, have never gotten loose again. And of course put in some marine grease.
SS set screw is 1/4 by 1/4-28 fine thread.
The wiper motors that use this push on design corrode and or wear the little splines, even a new blade did not fix the problem. I had prior done the other 2 wiper arms and now this new blade has gotten loose on the motor shaft.
Using a set screw also allows for easy positioning. The other two I did years ago, have never gotten loose again. And of course put in some marine grease.
SS set screw is 1/4 by 1/4-28 fine thread.