Thread Tools Display Modes
Old 01-22-2013, 06:40 PM   #1
Senior Member
Duvie's Avatar
Join Date: Nov 2011
Posts: 194
Anyone work with Weblon?

I am planning to replace the soft top on my flybridge enclosure as it has seen better days. It was made with Weblon and I plan to replace it with the same material. Has anyone worked with this material? I have purchased the Weblon and tried gluing a sample section using H66 glue. This seemed to make a terrific joint. I was going to glue then sew the seams but from what I saw in my test joint I wonder if there is any need to sew? If anyone has worked with Weblon or similar vinyl laminated polyester materials I would appreciate any guidance or tips. I have searched the internet and have found just about nothing on the subject. Leon

Duvie is offline   Reply With Quote
Old 01-22-2013, 08:12 PM   #2
Keith's Avatar
Vessel Name: Anastasia III
Vessel Model: Krogen 42
Join Date: Oct 2007
Posts: 2,716
Don't sew if you don't have to. It'll just perforate the material and weaken it as well as introduce holes. If you can cut with a hot knife, it would be better, as it will help seal the edges. The only weak spot is that the fibers will wick water inside the laminate. See if the mfg. has some tips about this.
Keith is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

All times are GMT -5. The time now is 12:33 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2006 - 2012