Go Back   Trawler Forum > Maintenance and Systems > Other Trawler Systems

Thread Tools Display Modes
Old 11-15-2015, 06:12 PM   #1
Senior Member
Dune's Avatar
City: Coastal SC
Country: USA
Vessel Model: Viking 65 CP MY (run at trawler speeds !)
Join Date: Jul 2015
Posts: 214
Cruisair programming control for continuous or intermittent fan ?

I have 5 units, two of them with SMX II controls... I found the instructions for programming the SMX II below.

The question is, can the older SMX I be programmed for the fan cycle as well ? If not, there must be an alternative method to achieve intermittent fan....as one of my SMX I units is intermittent fan but the other two are continuous. I would like to change those other two to intermittent as well. Any ideas how to do it ?



Continuous Or Intermittent Fan
(Factory set: Continuous)
You can select continuous fan operation or instruct the fan to
cycle on and off with the system compressor.
To select continuous or intermittent fan:
Enter the programming mode:
Press OFF.
Press SET.
Press DOWN, FAN and UP simultaneously.
Use the UP or DOWN key to select C (continuous) or I
Press OFF to exit the programming mode.

Dune is offline   Reply With Quote
Old 11-16-2015, 08:38 AM   #2
Senior Member
sum escape's Avatar
City: Muskegon, MI
Country: Cruising
Vessel Name: Sum Escape
Vessel Model: Grand Banks 47' Europa
Join Date: Jun 2014
Posts: 122
I think you just hold the fan button down for 5 seconds or so and it will switch.
sum escape is online now   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

All times are GMT -5. The time now is 01:31 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2006 - 2012