Have a wiper that just quit. Doesn’t appear to be a breaker or fuse, but will be sure motor is getting power. Is this failure most likely a motor if elect ok? Thinking of just swapping good motor to be sure. Thoughts?
Sevee another thought would be to run jumper between the 2 just to make sure this may be easier then swapping motors
Jump from the supply wires on the good side to the motor contacts on the bad side. If the motor is good and the circuit is bad, it will run. If not, it might be a bad motor.
A voltage check would probably accomplish the same thing.
Did you see any wiper smoke release from the motor? If it loses that smoke, it never runs again.
Jump from the supply wires on the good side to the motor contacts on the bad side. If the motor is good and the circuit is bad, it will run. If not, it might be a bad motor.
A voltage check would probably accomplish the same thing.
Did you see any wiper smoke release from the motor? If it loses that smoke, it never runs again.
Fly,
Smoke release? What's that?