The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

See posts with no answers

2016 06 11 MastTubes 002 Taped it all back together using packing tape which will serve as mould release. The strips should pop in and allow the rem

2016 06 11 MastTubes 005 Wet out the 'glass, and rolled the sticky mess into a square of plastic-covered aluminum flashing material and clamped with

2016 06 11 MastTubes 004 Another view of the pinched fiberglass. This allows me to roll the 'glass and twist it tight.

2016 06 11 MastTubes 003 Pinched the pre-cut fiberglass into the tube and clamped it with hose clamps.

2016 06 11 MastTubes 002 Taped it all back together using packing tape which will serve as mould release. The strips should pop in and allow the rem

2016 06 11 MastTubes 001 Inside mould for homemade fiberglass tubes. Cut a slice out of a bit of 2" PVC plumbing pipe. Added a strip of wood to acco

2016 06 09 MastPlan The chosen design. The table mounted to the flybridge seat is actually the tabernacle for the mast. Details to follow (when I f

2016 06 09 MastElev The chosen design. Original bronze maststep. Homemade fiberglass adapter for step-aluminum mast and aluminum mast to fiberglass

2016 06 11 MastTubes 002 Taped it all back together using packing tape which will serve as mould release. The strips should pop in and allow the rem

DHeckrotte
Jun 11, 2016

There are no comments to display.