The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

See posts with no answers

I backed the panel with cut pieces and used double edge tape at the center hold them. I stapled the outside since I cut it large so I can mark the fi

I failed miserably using the binding feeder. It does a good job but somehow I kept getting out of sync and had to do repairs that are now obvious. (

When I was as close as I was going to get, I stitched the outside edges to hold them together. You can sew right over the staples (I try to avoid the

My trusty LSZ-1 set up on two 6' folding tables. This gave me a large enough surface to work easily. I have also set it up on the table in the sailb

I backed the panel with cut pieces and used double edge tape at the center hold them. I stapled the outside since I cut it large so I can mark the fi

Checking the new panel with the old.

Cutting out the new panel. I used Sailrite's 24oz boat topping.

I laid the vinyl (removed from old panel) on the new panel to make sure I got it right. (Well, I got it close)

I backed the panel with cut pieces and used double edge tape at the center hold them. I stapled the outside since I cut it large so I can mark the fi

Lollygag
Oct 9, 2015

There are no comments to display.