The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

See posts with no answers

Then it was done, except for cutting the plug to size and banding it, I'll cut the frame when I finish the plug and install it with thickened epoxy t

This is a picture of the cross braces I put in to support the hatch and the flooring at the edges of the passageway. I was going to put them in verti

This is the plug, cut down to the marks made earlier, banded with the white oak I cut the other day and clamped tight.

Then it was done. You can see how small the trim pieces are. You can also see all the crap in the bilge. It was just dark and scary before. Now it

Then it was done, except for cutting the plug to size and banding it, I'll cut the frame when I finish the plug and install it with thickened epoxy t

I nailed down small pieces of wood to guide the edge of the vibrator. Then I sanded it with my small belt sander but try to get a picture of that.

Using the plug sides as a guide, I marked the new cut lines for the hole. Since i got it mostly right the first time, the new cuts were very small an

With the plug back in the hole, I lined up the teak and holly. Since I squared the plug it didn't line up with the sides of the hole so lined up it l

Then it was done, except for cutting the plug to size and banding it, I'll cut the frame when I finish the plug and install it with thickened epoxy t

Lollygag
Sep 6, 2014

There are no comments to display.